5 Attachment(s)
So I bought an Xmag but....
Hey guys i'm in need of some tech advice.
So I purchased an Xmag but I cannot get it to operate. I was told from the previous owner that it had not been used in at least 5 years, so I went ahead and ordered new o-rings for the Xvalve (they haven't arrived yet). Currently installed o-rings appear to be in "ok" condition... as in they aren't dry rotting. Upon inspection of the marker, it was not cleaned from the last time it was used. I cleaned out the barrel and oiled her up the best I could. I did not remove the rail from the body. I have a slight air leak at both ends of the macroline, but nothing from the valve itself... at least as far as I can tell. The bolt itself had a clear rubbery substance on the back of it but it was coming off (I replaced it with the blue foamie). For the life of me, I could not get it to shoot in any of modes (the board and batt are good). Somehow, I did manage to get it to shoot 4-5 rounds but then it went "dead" again (this is in mech mode). I understand that this might just be valve o-ring issues but I want to be progressive on this as it would take some time mailing it off to AGD or Tuna to fix from Japan. Oh... and on those 4-5 rounds that actually worked the bolt shot the rubber triangle thing off from the bolt :( I have another in my tool kit but what is the best method to use as far as adhesive goes? You can see that when gassed up the sear pin doesn't seem to protrude to the trigger (i'm not sure if thats normal on the Xmag, but it's not normal for my automag). I also placed the marker in ACE 0 and tried all ACE modes in attempts to get it to work.
Attached are the problem areas that i have identified thus far. The pic of the software version is to show that the board works.
Thanks in advance for the advice!
Attachment 90462Attachment 90463Attachment 90464Attachment 90465