AGD C/F frame - Crossman stock mod
Well OPBN ask the question and I was the guinea pig
https://automags.org/forums/showthrea...Will-this-work
First step was to check what was preventing the two from mating :D
as you can see they are close but material needs to be removed for the AGD frame to fit
http://i1325.photobucket.com/albums/...ps91ef6e41.jpg
i cut the back off the stock because it was in the way of the rear screw on the frame
http://i1325.photobucket.com/albums/...psa3770da4.jpg
as I refit and cleared away more material from the stock the frame became easier to insert :D
http://i1325.photobucket.com/albums/...ps83c3aca8.jpg
http://i1325.photobucket.com/albums/...psfe453564.jpg
I wanted to maintain the channel the posts on the frame ride in, but on the crossman frames the geometry is slightly different.
I took a used cutting wheel and cut the channel straight back. I used the painters tape as a guide
http://i1325.photobucket.com/albums/...psc7f9a951.jpg
http://i1325.photobucket.com/albums/...ps1104c819.jpg
i cleaned up the front and checked alignment again, and marked a spot for the new hole from stock to frame
http://i1325.photobucket.com/albums/...ps14db6480.jpg
http://i1325.photobucket.com/albums/...ps3be16ef9.jpg
using a hand file and sandpaper i cleaned up the back
http://i1325.photobucket.com/albums/...ps662796e4.jpg
Drilled and tapped the hole 10/32
http://i1325.photobucket.com/albums/...psb11ba6eb.jpg
http://i1325.photobucket.com/albums/...ps48c1554f.jpg
...and BOOM!!!
http://i1325.photobucket.com/albums/...psddcdf971.jpg
http://i1325.photobucket.com/albums/...psef72eab8.jpg