I'm building an EMag from parts and I need to know where the positive wire lead has to be soldered to the board?
A good closeup of the board/wire lead, anyone? It would help me a lot.
Thats pretty much all i need before its done.
Thanks in advance.
Printable View
I'm building an EMag from parts and I need to know where the positive wire lead has to be soldered to the board?
A good closeup of the board/wire lead, anyone? It would help me a lot.
Thats pretty much all i need before its done.
Thanks in advance.
Come on EMag owners, I just need one or two pics from the front and back of the wired board (no ace).
Try Tunaman or OneSelfLost. Either should be able to help you...
Quote:
Originally Posted by OPBN
Thats great OPBN, thank you very much! :cheers:
Solder the Positive wire in from behind the board. makes for a cleaner install, and the original wire is too short to make it around the board and up. Careful when soldering this in, there is a trace awfully close to it. If it is accidentally bridged, the microcontroller will damage when the power is applied. One side of the solenoid wire can be tied straight to the positive lead if you don't have the connector, as you can seen in OPBN's pic.