Results 1 to 2 of 2

Thread: Pump to Bolt action DIY guide. (Edited original post)

  1. #1
    Join Date
    Jun 2003
    Location
    KY
    Posts
    102

    Pump to Bolt action DIY guide. (Edited original post)

    DIY guide:
    Just in case any of you were interested. Cost is to cover expenses (pages of color copies, copyright etc)

    http://cgi.ebay.com/ebaymotors/ws/eB...ME:L:LCA:MT:31





    (Previous thread)

    I built this because I could not find one with all the features I wanted.
    No external hoses or lines. No external tank or changer. Bolt handle has to "unlock" before pulling to the rear. Most important was a quality wood stock, this one is from Boyds. Holds 3+1 just like a Remington .300 WinMag, although it will take any feeder that will fit on a Phantom side feed. 30 plus shots per 12 gram just like a normal Phantom.

    I decided to finish off the wood stock with spray on truck bed liner. Its texture and look are spot on to the M24. I was actually suprised, led me to think the M24 stock has the same finish over fiberglass.


    Finished except for a couple bare aluminum pieces:




    Close up of "bolt":


    This shows the lever quick change in the stock. Line runs through the stock to the valve body. NOT an easy task with a hand drill. Came out perfect.


    Original thread: https://www.automags.org/forums/showt...ht=bolt+action
    I fix guns, lots of guns, big guns. I need a job.

  2. #2
    Join Date
    Jul 2010
    Location
    Kitchener, Ontario,
    Posts
    281
    HOw did you set up the trigger.. any tips would be awesome!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •