Originally Posted by
Bassman
The problem I am having is that when aired up, pulling the trigger does nothing. The gun airs up, no leaks, and you can feel that the pin that the trigger activates is under pressure when pulling the trigger. I have tried adjusting the long pin that the trigger comes in direct contact with that pushes the sear to see if it just wasn't moving far enough but still no luck.
Another question too, can you install a ULT in a z-grip frame?
!
Make sure the trigger rod is not touching the back of the trigger when you hold the trigger against the safety with the valve aired up. There should be a tiny gap (credit card thickness).
Make sure the level 10 bolt is properly tuned. Remove all shims from the powertube and install the largest carrier size that does not produce a leak with the white carrier oring that you are using. Always use the same white oring in each carrier that you try. Don't install the shims.
You might want to try a shorter on-off pin if you have access to one.
Except for the Automag in front, its usually the man behind the equipment that counts.