my mag has xvalve with ult but shoots rapid fire when trigger is pressed the xvalve has 3 shims and ult has none i want to make it so i can walk the trigger. Can anyone help with tunning
my mag has xvalve with ult but shoots rapid fire when trigger is pressed the xvalve has 3 shims and ult has none i want to make it so i can walk the trigger. Can anyone help with tunning
Take the shims out of the Level X, tune it and try again. Also, measure your on/off pin to see what length it is.
How do you tune itOriginally Posted by OPBN
You mean the trigger armOriginally Posted by Xris28
check out these threads for info:
https://www.automags.org/forums/showthread.php?t=43538
https://www.automags.org/forums/showthread.php?t=96538
also check your sear? check the reg pin o-rings? maybe post pics of your set up? and/or your Mag set up?
maybe your pin is short?
You shouldnt have to have shims in your level X. Take the shims out of it and go through the steps to properly tune the Level X. Once you have done that, retune the ULT.Originally Posted by Xris28
You mention walking the trigger. What frame do you have? Does it have trigger stops? Some frames are easier to get walkable than others, but even then, a ULT is not typically going to be as walkable as an electro trigger.
Sounds like pics would be best.
While the level 10 probably doesn't need shims, it shouldn't be causing excessive rapid fire.
Take all of the shims out of the ULT as well.
Besides OPBN's questions above, what kind of air tank are you using?