Results 1 to 28 of 28

Thread: Gumshoe Rail

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Jan 2001
    Location
    Cottonwood, Az.
    Posts
    8,183

    Gumshoe Rail

    This rail design was talked about a few months back, there was some interest at the time so I went ahead and did the prototypes to test the programming.

    Engraving shown would NOT be standard but an add-on.
    Rails are ULE milled with foregrip slots.
    Automag rails would have a duel slot for use with both AGD style VASA's.
    RTP full length slot for 2 screw VASA.
    Both rails match factory lengths.
    Milled for all body styles.
    RTP is 1.00" wide.
    AM rail is 0.98"
    Both rails can be pump milled.
    Rails are machined from 6061 billet.

    There's not a 'bump out' around the sear on the RTP, you can grind a little off the sear tip and it will sit in the frame like shown in the picture.
    Last edited by luke; 11-25-2013 at 01:24 PM.

  2. #2
    Join Date
    Jan 2001
    Location
    Cottonwood, Az.
    Posts
    8,183
    Right hand side>



    RHS


    LHS
    Last edited by luke; 11-25-2013 at 01:32 PM.

  3. #3
    Mine mine

  4. #4
    Join Date
    Mar 2003
    Location
    St. Louis
    Posts
    5,055
    very nice, lmk if prototypes go for sale

    --atleast KNM diddnt beat me ...

  5. #5
    Join Date
    Jan 2001
    Location
    Cottonwood, Az.
    Posts
    8,183
    PT's are available, I have 1 AM and 1 RTP, not pump milled.

  6. #6
    Join Date
    Aug 2011
    Location
    Marseille - France
    Posts
    534
    Pm

  7. #7
    Join Date
    Nov 2000
    Location
    Milwaukee WI
    Posts
    1,392
    So the RTP style will accomodate frames with 'wings'?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •