-
Micro ca question
Does anyone know what thread the check valve threads are on the front of the valve of a micro ca.
-
Probably 3/8 fine. Its a standard thread.
AGD
-
Thank you sir. The Pbc guys say thanks.
-
where would i go about getting a roll pin pressed into the lever? is that something agd would do?
-
Do you mean the end of the lever, where you would grab to release it of the pivot point. You should be able to put the pivot one in without any issue, just tap it. If it is the other one I would imagine any local machine shop could help you.
-
ya the end of the lever one that you grab.
-
if you have a drill press or access to a drill press that would be the way to go…I'm pretty sure thats wat a machinist would do.
-
i do actually. may have to try that thank you sir.
-
its all good! post up with some pics when ya got it all finished.
-
ended up getting a 6-pak.
what size roll pin am i looking for?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules