Results 1 to 10 of 10

Thread: Micro ca question

  1. #1
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741

    Micro ca question

    Does anyone know what thread the check valve threads are on the front of the valve of a micro ca.

  2. #2
    Join Date
    Oct 2000
    Location
    Chicago
    Posts
    5,916
    Probably 3/8 fine. Its a standard thread.

    AGD

  3. #3
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741
    Thank you sir. The Pbc guys say thanks.

  4. #4
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741
    where would i go about getting a roll pin pressed into the lever? is that something agd would do?

  5. #5
    Join Date
    Jul 2002
    Location
    Western Mass
    Posts
    582
    Do you mean the end of the lever, where you would grab to release it of the pivot point. You should be able to put the pivot one in without any issue, just tap it. If it is the other one I would imagine any local machine shop could help you.

  6. #6
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741
    ya the end of the lever one that you grab.

  7. #7
    Join Date
    Feb 2011
    Location
    PHX, AZ
    Posts
    1,441
    if you have a drill press or access to a drill press that would be the way to go…I'm pretty sure thats wat a machinist would do.

  8. #8
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741
    i do actually. may have to try that thank you sir.

  9. #9
    Join Date
    Feb 2011
    Location
    PHX, AZ
    Posts
    1,441
    its all good! post up with some pics when ya got it all finished.

  10. #10
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741
    ended up getting a 6-pak.

    what size roll pin am i looking for?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •