-
pics would be great. i haven'f found a local hardware store that had a 7/32" roll pin or a 3/8" plug small enough and was about to order them on mcmastercarr.
-
Looking good guys! I'll wait a few more days and publish this in the AO Archives.
-
on wow thats awesome! My brother and i always wanted one of these when we were younger. I lost my brother to a car accident when i was 16. Some day ive gotta get my hands on one of these....just because.
-
This is what the check valve on my Micro CA2 looks like in the order the parts came out.
The spring and seal don't match anything in any of my Automag parts kits. The seal is a hard plastic and the approximate dimensions are below. I took the measurements with a caliper not a micrometer so they might not be exact.
Jam Nut, 3/8"-24 x 3/16"
Spring width, 5/16"
Spring length uncompressed, 3/8"
Spring length compressed, a little under 1/8"
Bearing, 5/16"
Seal outside, .32
Seal inside, .15
Seal thickness, .05
Last edited by BLachance75; 04-07-2014 at 08:33 AM.
Reason: added additional measurements
-
What's the length of the jam screw?
I was thinking about making one similar to this.
-
I'll measure it later tonight, I already left for the day.
-
anyone know where i can get a 7/32" x 1 3/4" roll pin with out having to buy 100 on mcmastercarr?
also does anyone else have any other check valve setups? im looking at making one and not sure how i want to go about doing it.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules