Super Glue - Trigger Frame To Body

[Smudger]

I was wondering why the front allen bolt was so difficult to remove from the front of the trigger frame, well after a bit of "entertainment" I found that super glue has been used on the trigger frame to body.

All of it it seems, maybe even the thread of the allen bolt.

So idea's on how to remove this.

I have tried acetone (which normally works to remove super glue) but no joy so far.

Cheers

[yellowmitten]

try mixing 1 part acetone with 1 part WD-40. If you need it to stay put for long periods of time or on vertical surfaces, mix in some petroleum jelly. Apply a good thick coat of this mixture.

[Smudger]

The problem I have is getting it to the superglue. I would say around 1mm gap.

So applying anything other than a liquid/spray isn't possible.

But thanks for adding something to try!

Smudger

[SPLATTER-ZONED]

Epoxy an allen key to the suck bolt and reef on it after it's fully cured.

SZ

[yellowmitten]

could always boil the gun so long as you have a parts kit to replace the O rings.

[cockerpunk]

could always boil the gun so long as you have a parts kit to replace the O rings.

take the valve out and theres no orings to deal with.