pneumag classic help

[ascent]

Hey everyone, I just installed a pneumag frame on my classic. Now, i am assuming that the pneumag frame is working, and the classic was working before hand...
I started by installing an rt on/ff, then the complete frame swap....

Pulled the bit off the sear that you dont need....

when i pull the trigger, the pneuframe works, but it doesn't trip the on off at all... any ideas?

Should i not have the two the orings in the on off that were there with the classic on off?

do i need a different sear?

Tested it with the classic on off too... No change. Is it lvl 10 related?

thanks!

[Cyco-Dude]

you do need the two o-rings there, you shouldn't need a different sear. what length on/off pin are you using? if it's the wrong size (should be .750), it could cause the gun to not work. if that's fine, it sounds like the actuator isn't pushing the sear far enough? what exactly do you mean by "doesn't trip the on/off"? does the sear not release the bolt? does air leak from the on/off?

lol, i need to refresh more often, geez...late reply.

[ascent]

you do need the two o-rings there, you shouldn't need a different sear. what length on/off pin are you using? if it's the wrong size (should be .750), it could cause the gun to not work. if that's fine, it sounds like the actuator isn't pushing the sear far enough? what exactly do you mean by "doesn't trip the on/off"? does the sear not release the bolt? does air leak from the on/off?

lol, i need to refresh more often, geez...late reply.

the sear was contacting the top of whatever pneu part is up top. i just had to pull it out and seat it better. this thing is a hair trigger... just think it really needs trigger stops installed and a magnet mod installed. is there anyone on here that would be able to do that for me? i don't like drilling things, i make too many mistakes.

[Cyco-Dude]

i think luke is the man for that job. trigger mods here, or if you prefer, you can buy a new trigger.

[ascent]

Thanks man. I'll pick one of those up.

[captian pinky]

If it's not tripping the rt on/off increase the lpr pressure it was setup for a ult before.

[ascent]

classic valve
lvl10
rt on/off
plamers lpr @ ?psi (turned it up till it vented, still nothing... turned it all the way down, nothing) currently set to a little less pressure then needed to make it leak.
classic rail
ule body
pneu intelliframe
classic sear

pneu frame vents with a hiss when i pull the trigger, but it moves...
on off pin keeps getting stuck out on both the classic on off and rt one... have to remove the rail to dissemble .

if i were to say one thing stands out, its that the sear really cant move for whatever reason tried tripping it by hand and its like frozen in there with everything together

think i found the issue. the front of the sear is contacting the top of the pnu setup keeping it from moving like it should....should i grind down the sear till it can move freely?



EDIT
aaaand working.... the sear was contacting the top of the pneu parts and not moving.......