Does anyone know where I can get full Oring kits for 2 cockers? I need kits for a karnivor and also freeflow.
Does anyone know where I can get full Oring kits for 2 cockers? I need kits for a karnivor and also freeflow.
If you get me the sizes, i can make you up 2 sets of orings.
Wikkid
Ouch, that PBGateway kit is expensive. I have kits that include a whole bunch of useful hardware too for a few more dollars. Sorry, I don't sell the o-rings separately.
http://www.mcarterbrown.com/forums/d...k-sliders.html
Autococker Parts Kit. This is an Autococker parts kit that every Cocker owner should have. The following is included (everything pictured):
1x complete Autococker o-ring rebuild kit
1 sear pin to hold your sear in place
1 improved hex-head stainless vertical ASA screw
1 valve jam nut
1 valve guide screw
4x set screws for timing rods (2 each of the two different sizes)
1x beavertail washer
8x trigger frame and beavertail screws (4 in stainless and 4 in black)
1 foot section of high quality black pneumatic hose - max pressure of 250 psi (more than twice the working pressure of an Autococker)
Last edited by MAGgot; 09-12-2014 at 09:13 AM.
Doug I need some 003 orings.
I guess I'm used to paying for AGD kits, so $14 seemed like a steal.
Lol no doubt.
oringmonkey.com ?
Found this
AUTOCOCKER O-RING SIZES
AS568 SIZE : ID x SC [mm]; DURAMETER
Old Valve Guide sticking ring: 12.0 x 1.00; 50 or 60
003 3-Way: 1.42 x 1.52; 40[*]
006 fill nipple: 2.90 x 1.78; 90
008 WGP Regulators: 4.47 x 1.78; 55
010 Ram shaft o-ring: 6.07 x 1.78; 70
012 Valve Guide o-ring: 9.25 x 1.78; 70
015 Standard: 14.00 x 1.78; 70 [@] (get lots of these)
112 Robust: 12.37 x 2.62; 70 [@] (used on regs etc)
113 Big O-ring: 13.94 x 2.62; 70 (used on some parts)
Lucky 15 barrel: 21.00 x 1.00; 70
Info:
*: Polyurethane o-rings suggested.
@: Polyurethane 40-60 o-rings suggested for bolt o-rings.
OTHERS
(AS568) SIZE: ID x OD x HT [mm]; DURAMETER
Eclipse Qev Rubber disc: 3.5 x 7.00 x 0.75; 70
ANS Cocker Valve disc: 7.0 x 12.0 x 1.50; 90 or 100
__________________