I have a problem that I cannot figure out. I have an ULE Custom with an X-Valve and Intelliframe. I have the switch for the warp feed in the trigger frame. When I pull the trigger, sometimes it fires, sometimes it does not. The majority of the time, the trigger is spongy and will not trip the sear.
What I have done thus far:
- measured the trigger rod length - validated to be 1.985"
- measured the on/off pin length - validated to be .750 (stock on/off pin)
- swapped the intelliframe with 68 automag metal trigger frame (marker cycles)
- adjusted regulator pressure
- placed valve in another marker (cycles properly)
- removed the switch for the warp feed
I am at a loss. Any thoughts?