Hello all,
I found the following picture of AutoMaggerIX's pistol Mag from 2008:
(originally from this thread)
Can anyone identify the circled part that connects the Warp feed neck to the feed tubes?
Thanks!
Hello all,
I found the following picture of AutoMaggerIX's pistol Mag from 2008:
(originally from this thread)
Can anyone identify the circled part that connects the Warp feed neck to the feed tubes?
Thanks!
I'm guessing 3/4" CPVC that's been rattlecan'd black.
PVC sounds about right. We used to use it for feedtube adapters when using 10 round tubes. If you heat the end of a 3/4" PVC pipe until it gets soft and shove the rounded end of a 10 round feed tube into it and let it cool, it is a perfect fit for the 10 round tube and makes for a nice adapter.
Except for the Automag in front, its usually the man behind the equipment that counts.
Thanks for the suggestion for PVC connections. Dropped by Home Depot and realized it's actually 1/2" PVC. Will require some sanding and fitting, but it should work!
Its 1/2" if you are using adapters because the adapters have to fit the larger outside diameter of the pipe not the measured inside diameter. You use 3/4" if you are using the pipe itself, because its the 3/4" inside diameter that you need.