Hey all,
Need help from everyone using lvl 10's in their mag(s). Im looking to see what size carriers are used the most. Im trying put a set together and dont want to have to buy all of them. So what do you use? post below
Thanks
Hey all,
Need help from everyone using lvl 10's in their mag(s). Im looking to see what size carriers are used the most. Im trying put a set together and dont want to have to buy all of them. So what do you use? post below
Thanks
Last edited by gotzskillz; 03-05-2015 at 06:28 PM.
Each gun uses its own carrier and shims. There is no one setup. Start with the smallest(no line, no dot) and go up. The sizes of carriers used will always depend on the individual valve.
Thanks, Nobody. Guess I should of described what I was asking better.
I know that every valve is different and uses different carriers because of oring variances. What Im trying to find is the most commonly used carriers so I can put a set together.
sorry for the confusion. Ill edit the original post.
well, new lvl 10 kits come with 0, 0.5, 1 and 1.5 only. in my experience, i have not used the sizes larger than 2.5.
if it were me, i would do 0.5-2 if you wanted to spend the least, or 0-2.5 if you wanted to cover pretty much all of your bases.
I've never seen one larger than a 2.5 in a valve. I have heard of people using size 0. The size 0 to 2.5 is the range you should keep on hand for all situations.
Except for the Automag in front, its usually the man behind the equipment that counts.