hyperframe with morlock problem
hello,
I have a mag with an RT valve using a ULT and LX and a hyperframe with pred morlock board. This was my tourny gun long ago. I always had issues with the hyperjunk, from day one. One problem I can't solve is bolt stick. When I rapid fire, 10 bps+ the bolt will stick forward and I need to use a squeegee to reset it or sometimes smack the valve hard in the back....
My thoughts are
sear gap: I will check that tomorrow... the sear may not have enough clearance from the noid. I would think the same credit card thickness gap should be there as in needed in the trigger rod to trigger
Programming: maybe I have the board set up wrong, it would be nice if I could find some devil mag owners who could share their settings with me
Capacitor: Have Blue installed the board for me, he put in a capacitor like the stock board had... maybe it is the wrong side for the job or recharges to slowly.... again info from devil mag owners or even hyper frame owners would be nice
On/off length: I ran the largest pin centerflag had back in the day before I switched to ULT to try to fix the problem. I could check my shim stack and try a longer pin... would like to try the longest setting possible to see if that makes any difference
So yeah, any other ideas? Anyone know a devil mag owner who might help? I want to get this running I am going to play at the end of next month and want this gun to work to it's potential
Tom was the last of a now extinct breed, a breed of players who build a community, a breed of owners who gave to the sport never taking more than what they deserved. I hope to see you at the feild again some day....