Xvalve,
Luke's ul rail,
Intelliframe
Am/mm sear

I believe I may be experiencing issues with body/valve alignment.

I gas up the marker, and it gets pressure on the sear pin, but it's stuck up, can't get it to fire.

It seems like the answer seems to be to adjust The thumb screw on the back with s wrench.

The marker is gassed up still, I slowly tighten the valve down until it clicks, and the sear pin pops forward to where it should be.

It will fire, pretty good usually, but then go back to being stuck again for apparently no reason??

I'm thinking Two possibilities

1 my rail is possibly out of spec?

2 I noticed the screw I have going through the grip frame does not sit completely flush, and I'm wondering if this is causing the intelliframe to sit funky.

Now I read briefly another thread on this forum mentioning that was an issue with the intelliframe and was meant to be fixed.

I have just a standard 10-32 bolt going through the front. There is an agd brand thumb screw on the back, and an agd rail bushing.

Should I seek out the proper washer/screw for the frame?

Do I need an rt spec rail for being xvalve system?

Jim