Registered User
Two mags work just fine when the harness is not plugged in, but as soon as I plug it in one board turns off right away and the other board fires once then turns off. One emag worked just fine prior to switching the harnesses between the guns. Any suggestions as to what it could be?
I am not sure it is as simple as a new hall harness as the one that was working prior to me trying to put it on the non working harness gun is now a not working.
Any help would be appreciated!
I could tell you but then.
What board is it?
www.BigEvilOnline.com
Trigger magnet is too close. Back it off.
PrestonCoPaintball
yep yepOriginally Posted by bigevil
Registered User
Tried to back off the magnet with no luck. I believe both emags have stock boards. One has 3.2 software and that other has 1.8 software. If I unplug the hall harness the board lights up and I can move through the settings. When I plug it in the board won't light up. It should tell me what software I have as soon as I put power to it and it doesn't say anything until I unplug the hall harness and put power back to it. Not sure what is wrong. I have the same problem with both emags so I'm puzzled.
Nobody's Perfect
Check the ground screw. Make sure that it has good, clean contract with the frame.
I could tell you but then.
Why would that turn off the board?
PrestonCoPaintball
If the magnet starts out too close the sensor it won't let it power up , a magnet thats backwards make it do weird stuff tooWhy would that turn off the board?
Registered User
Thanks guys. I got them working. The magnet was too close and wouldn't let the gun fire. I'm new to emags but I'm learning fast.
Posting Permissions
Reply With Quote