has anyone got the dimensions of the brass top hat in the on/off for a Classic valve
I haven't got one to hand to measure and a friend has lost his, so I thought it would be easier just to knock him up one at work.
Any input appreciated
Cheers
Ren
has anyone got the dimensions of the brass top hat in the on/off for a Classic valve
I haven't got one to hand to measure and a friend has lost his, so I thought it would be easier just to knock him up one at work.
Any input appreciated
Cheers
Ren
On/Off Top <----link to product
They cost $7.00 for new one....probably 100's laying around used for less.
I guarantee you will spend at least $200 in time making one.
If it was A $100 part.....maybe...it might be worth it...
AGD is in the house!
Custom gun builds. All the parts. New Website. Factory Service available!
www.airgundesigns.com
there cheap as chips I know, but being in the UK has its down points when it comes to mag stuff (:
it would take me 5 mins on my collet lathe to make one tbh perks of being an engineer
only want to get a classic valve back up and running for a friend
I'll try to remember to dig one out.
Ill take some measurements when i get home today.
Thank you guys appreciate it
I had remembered on the way home, but that thought was destroyed when I got there. We have a wedding going on this weekend, chaos reigns. I have hope still.
Thickness = 0.1865"
Diameter = 0.3715"
ID - 0.1475"
ports (4) = 0.0875"
small diameter/waist = 0.271"
waist height = ~ 0.115" it looks half-circular between the inner and outer diameters, so that would be about right.
Thank you