Caustic Customs Noxious ULE Emag *SOLD*
I find this too gorgeous to use so it has to go.
- Venomous Designs Noxious Body & Rail (Body lightly milled for CCM air fitting clearance)
- Venomous Designs Snatch Grip
- X-Valve w/ Emag on/off and Level 10 bolt.
- X-Valve Efficiency Insert
- Emag lowers ULE & T-Slot Milled (by Luke)
- Battery Housing Milling (by Luke)
- Battery Housing Bottom Cap ULE Milling (by Luke)
- Luke's Aluminum grips, contoured for comfort
- Luke's Aluminum selector switch
- Pooty Freak-bored shaft four clone barrel
- PE POPS ASA
- Ego Clamping Feedneck
- Tunablade
- Sanded Kila Detents
- Jai's (Painbal4me) Reflex board
- Stainless Steel Screws for Battery Housing
- HES vanity cover (just an idea I wanted to try)
- 720mA Battery is in good shape and holds a charge. Has a date of 3/8/12 written on it from Tuna.
- Comes with battery charger and DC cord/plug
And a ridiculously nice (and expensive) Caustic Customs Ano
The gun has been assembled, powers up, airs up and doesn't leak, and fires without a problem, but it definitely needs to be tuned. I haven't played with any of the board settings.
I'd rate the condition at a 9.5/10; the trigger frame shows some small, pre-ano remnants of the punch pin dings around the trigger pin. There also appears to be a light scratch that didn't polish out before ano on the driver's side left "fin" on the top rear of the body. I tried to capture it here:
Anyway, this is the nicest gun I've ever owned and I'd say it's easily nicer than my mag that won MOTY.
Between parts, milling, and ano, I have over $2300 in this.
Asking $1650 shipped and insured CON-US. SOLD
I will entertain trades in my favor, but cash is king.
Please post here first and follow it up with a PM.
Thanks, AO!
Reply With Quote
