So I got this mag together today to tinker.
It has an xmt carbon fiber 3 piece? body.
The front carbon fiber tube slides on and off quite easily. The back part is quite difficult to move. Regardless every 10 shots or so the rear body piece inches it's way back towards the valve, at about 1/16 gap at the front and touching the xvalve at the back it stops the marker from firing completely. It's easy enough to pull the valve and shove it back into place. I've tried varying tightnesses of frame bolt and thumb screw and it doesn't seem to matter there.

I was hoping not to glue or epoxy it on yet and play a few games while I finish the build and send away for anno.

My question here then is what kind of adhesive should I use when it is all complete?
Super glue?
Jb weld?
Jam some chewing gum in there temporarily?

Sent from my SM-G920W8 using Tapatalk