-
Autococker body kits and bodies
I need some money for a new computer build so some of these need to go.
All prices are shipped anywhere USPS flat rate boxes go.
Mini E-Orracle black to yellow fade $150 SOLD
Completely Empty
Held air and cycled when I had it built out
Karnivor Noid
DLC delrin trigger
Electric tap only there to keep the back block with the kit so I dont lose it.
Matching Eblade frame
Mini E-Orracle blue $130
Completely Empty
Held air and cycled when I had it built out
Matching Karnivor Eblade frame
Karnivor Trigger
Looks like someone tried to sand the inside of the feedneck. Works fine with my halo b and revy but there are marks inside the feedneck.
Outkast body and parts $110 SOLD
Completely Empty
Not Drilled
Held air and cycled when I had it built out
WGP swing trigger frame
3 way
LPR
Body is in great shape. Would recommend replacing the LPR as the threads seem to be wonkey. It only threads in easily so far.
Red black magic body $90
Completely Empty
Held air and cycled when I had it built out
Drilled
Pre 2k Right feed $165
Never had air through this one
Has all internals, Assume stock
Dye slider frame
3 way
lpr
Needs: Detent, Ram, bolt pin, asa, pump arm.
Can include the ANS ram, a detent, and pump arm for some extra. There is a piece of rod in place of a bolt pin as a temp place holder as I never had the old style pin for it.
Last edited by boomer89; 02-23-2018 at 08:51 AM.
-
On to the bodies that I modded
2k4 green and black $90 SOLD
Completely Empty
Held air and cycled when I had it built out
One of my earlier Anodizing projects so the colors are not perfect but still looks pretty cool
Mid blocked
Removed rear rail and cut for mid block sled
Mini'd midget'd halfblocked nightkast/outkast $60
Completely Empty
This way my test body. Its been anodized and milled a couple of times.
Mini'd and halfblocked first, anodized, built, stripped, midget'd, and reanodized
Ran fine before I midget'd it and reanodized for the last time. Never built it again afterwards
I stripped the front block and never got around to reanodizing so it is raw.
halfblocked 2k4 raw $40
Completely Empty
Mill crashed on halfblock. I straighten it out but there is the low spot pictured
Also removed the front wings
Last edited by boomer89; 02-23-2018 at 08:52 AM.
-
Good luck on the computer build! I was pretty happy with my Ryzen build i did.
-
I want outkast body and parts. Are there still available? And will they fit my new makita xbu02pt?
Last edited by jimmydiaz; 03-02-2018 at 06:48 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules