NOTE: When using the Hybrid rail on an AGD Emag the new solenoid plunger measurement is 2.9336" to 2.9386"
Introducing the new Hybrid RTP Rail.
The new design features a redesigned sear pin that is an off the shelf dowel pin which uses two 4-40 set screws to hold it in place.
Manufactured slug rail size is as follows: 9.2" long, 1.25" wide, and .572" thick
Finished rails can be as long as the AGD ULE body.
Its the thickness of an Automag rail and the length of the Original RTP rail and wide enough to cover many designs.
Rails can be used with twistlock barrels, stainless steel and ULE bodies.
A sear pin as short as 0.625" can be used. Rail designs will no longer be dictated by the factory sear pin.
All rails will be sold with replacement sear pins and hardware.
For those that don't know, all Lc Rails are manufactured from slug rails, they're the first step in all rail designs.
Manufacturing of the slug rails begin tomorrow and will finish up this coming week.
In the past, there were rail designs that were only available for the old Automag rails, now all those designs can be made from these slugs.