|
#1
05-31-2009, 08:04 PM
|
|||
|
|||
|
Questions about X-Valve/CO2...
I know your not supposed to use CO2 with an X-Valve but I was wondering if I could use 12 grams on a pump mag I'm making... I figure your not supposed to use CO2 sue to the intended high ROF of an X-Valve but with the pump it would be a relatively low ROF, shouldn't get too cold. Anyone try this before?
Thanks, Cole 
|
|
#2
05-31-2009, 08:16 PM
|
|||
|
|||
|
it would probly work, but I dont reccomend it. if you want a small tank get a 13ci tank.
|
|
#3
05-31-2009, 08:18 PM
|
|||
|
|||
|
Yes i'm sure it has been done , just saw one on here the other day somewhere
|
|
#4
05-31-2009, 09:05 PM
|
|||
|
|||
|
ive got a 13... i just wanna run a bucket changer up front... ill give it a shot.
|
|
#5
05-31-2009, 09:28 PM
|
|||
|
|||
|
It will ruin the valve. If you freeze the red silicone oring sealing the powertube repeatedly it will fail. You don't want to do that. Get a cheap classic valve and be done with it.
|
|
#6
06-03-2009, 08:13 PM
|
|||
|
|||
|
ill take your word for it... compressed air it is.
Cole
|
|
#7
06-03-2009, 08:16 PM
|
|||
|
|||
|
any where I can get one new?
|
|
#8
06-03-2009, 08:16 PM
|
|||
|
|||
|
Bucket changer or 13ci ?
Last edited by secretweaponevan : 06-03-2009 at 08:22 PM.
|
|
#9
06-03-2009, 08:33 PM
|
|||
|
|||
|
Neither! I was talking about the classic valve.
Thanks, Cole
|
|
#10
06-03-2009, 08:52 PM
|
|||
|
|||
|
Quote:
Oh, hehe. The BST here, on MCB or on Ebay. The only thing that really wears out is o-rings, so any one you get will perform like new after 5 bucks in rubber.
|
|
#11
06-04-2009, 05:08 AM
|
|||
|
|||
|
Quote:
|
|
#12
06-04-2009, 08:28 PM
|
|||
|
|||
|
i may within the next week. First I have to get the rail and ASA I ordered from you and send it to warpedmephisto for milling.
Cole
|
 |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
