Mario pulled it off..
Saved the zlock pin, aligns the exact same way and works perfectly!
Sent from my SM-G960U using Tapatalk
Mario pulled it off..
Saved the zlock pin, aligns the exact same way and works perfectly!
Sent from my SM-G960U using Tapatalk
Nice, but what's been the main hinderance? Is it something beyond masking off the threads, mating surfaces and z-lock pin I never understood?
>>WTB<< Sydarm w/ constant air__WarpedMephisto half-c/f body__Ac!d c/f trigger__TASO humpback frame__an Oh-Mag
Nice
People butcher them..
Sent from my SM-G960U using Tapatalk
If anyone would know the reason people ruin Xvalves trying to re-anno them Tuna would.
AGD products are all pretty much built to very stringent tolerances. When the valve is stripped if it sits in the acid bath (I believe) too long some of the aluminum is "eaten away" possibly making the valve out of spec. Thie is where the fear comes in and why a raw valve is considered by some to be the only option.
......You know you want one!!
That is correct. If the z lock pin is already installed, it was done after the original anno job. When you reanno it incorrectly it takes off too much material and the valve halves screw together further than needed...and the z lock pin doesnt work any more. If you get the z lock pin situated in the rail, you wont be able to get the field strip screw in with out cracking the valve halves apart a bit...causing the valve to leak beyond repair. I have had to break the bad news to many a customer over the years that sent me reannoed valves for assembly...only to tell them the valve is ruined..