Mech Emag valve optimal pressure

[paintball4lyfe32]

Dusting off my mech ule mag with emag valve. I thought I remembered something about the higher the tank output pressure, higher bps is achievable. Is this true? More importantly, what is the optimal output tank pressure?

If you’re feeling ambitious, what are other ways to increase bps?

Thanks AO community!

[vintage]

the higher the output pressure of the tank the easier it is to sweet spot the rt effect and it will shoot faster though it's not recommended. a lot of people shorten the on off pin instead of using the extra high pressure to get the same effect. 800 psi is the recommended output pressure for most valves to run consistently.

[paintball4lyfe32]

Thank you for the insight! I will explore the on off pin option. I have the benchmark double trigger frame. Are there any trigger frames that would improve performance?

[vintage]

benchmark frames have a sloppy trigger making it a little harder to sweet spot but it's doable. the old intelliframe works well.

[luke]

Are there any trigger frames that would improve performance?

Yes indeed, I have 7 frames to choose from, all pneumatic or mechanical without any necessary modifications.

Lc MP90d>

[paintball4lyfe32]

Thanks for the replies, huge help! I may just have to splurge a little on one of those frames Glad to see your still producing them, I’ve considered buying one years ago.

[paintball4lyfe32]

Have an idea if any more x valves will be produced and when?
I definitely scoop up one of those frames from you Luke if I could obtain an x valve.